Hi,

Wasn't sure where to post this, though this part of the forum is where I'm having the problem.

I ordered the new software which arrived and I promptly install, which went in no problem. It scanned for the channels and due to me hooking up to a cable box it found the analogue channel and played it fine - though it was a little distorted which I was expecting.

The problem came when I came to use the extend software on the iPad. This stated that the software on the pc was out of date. So I downloaded and installed, it found the channel again and showed a better picture, but no audio except static noise like theres no channel.

So I've tried the following:

Old software old driver : works fine
Old software new driver : works fine
New software old driver : video but no audio
New software new driver : video but no audio

Can anyone give any advice on what to do please??