SilentException
04-02-2011, 11:10 PM
Having a good experiences with my HVR-2200, I bought Nova-TD for laptop.
After installing drivers and putting it to two tuner mode, I've done some initial scans with no success (nothing found).
A friend then told me about the tool (from this forum) for manual scanning. So I gave it a go. On two different locations, different country, more than 200km away (and 3 sub-locations on each of the two), I couldn't find any channels (doing a full frequency scan).
I'm using an amplified room antenna which I have put: 1. inside, 2. outside the window, 3. on the balcony. Both 2. and 3. on both locations have almost unobstructed air view to the emitter.
I don't understand what else might be wrong but the card being defective in some way. But maybe you can point me to something to confirm that. If it helps, the light on the card is blue on first diode for most of the time. I've seen it go in "both diode yellow" mode occasionally.
Thanks for the help!
PS. Oh, this is from the scanning tool logs:
# locking 530000, 8
# signal locked = N present = N strength = 0 quality = -100
...
...same for every single channel.
Cheers! :)
After installing drivers and putting it to two tuner mode, I've done some initial scans with no success (nothing found).
A friend then told me about the tool (from this forum) for manual scanning. So I gave it a go. On two different locations, different country, more than 200km away (and 3 sub-locations on each of the two), I couldn't find any channels (doing a full frequency scan).
I'm using an amplified room antenna which I have put: 1. inside, 2. outside the window, 3. on the balcony. Both 2. and 3. on both locations have almost unobstructed air view to the emitter.
I don't understand what else might be wrong but the card being defective in some way. But maybe you can point me to something to confirm that. If it helps, the light on the card is blue on first diode for most of the time. I've seen it go in "both diode yellow" mode occasionally.
Thanks for the help!
PS. Oh, this is from the scanning tool logs:
# locking 530000, 8
# signal locked = N present = N strength = 0 quality = -100
...
...same for every single channel.
Cheers! :)